Download
Table of Contents > DTC P2648: Rocker Arm Oil Control Solenoid Circuit Low Voltage

Honda CR-V Programmed Fuel Injection (PGM-FI) system ➜ DTC P2648: Rocker Arm Oil Control Solenoid Circuit Low Voltage

Fig. 412: DTC Troubleshooting Flow Chart (P2648)  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
NOTE:  
Before you troubleshoot, record all freeze data and any on-board snapshot, and  
review the general troubleshooting information See HOW TO TROUBLESHOOT  
THE FUEL AND EMISSIONS SYSTEMS or HOW TO TROUBLESHOOT THE A/T  
SYSTEM .  
Confirmed  
DTC  
Pending  
DTC  
Freeze  
Frame  
DTC Description  
P2648 ROCKER ARM OIL CONTROL SOLENOID  
CIRCUIT LOW VOLTAGE  
1. Problem verification:  
ο‚‘
ο‚‘
1. Turn the ignition switch to ON (II).  
2. Clear the DTC with the HDS See HOW TO TROUBLESHOOT THE FUEL AND  
EMISSIONS SYSTEMS or HOW TO TROUBLESHOOT THE A/T SYSTEM .  
ο‚‘
3. Do the VTEC TEST in the INSPECTION MENU with the HDS.  
Is the result OK?  
YES : Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at  
the rocker arm oil pressure switch, the rocker arm oil control solenoid, and the PCM.  
NO : The failure is duplicated. Go to step 2.  
2. Rocker arm oil control solenoid internal resistance check:  
ο‚‘
1. Turn the ignition switch to LOCK (0).  
2. Disconnect the following connector.  
ο‚‘
Rocker arm oil control solenoid 2P connector  
ο‚‘
3. At the rocker arm oil control solenoid side, measure the resistance between test points 1 and 2.  
Test condition IG LOCK (0)  
Rocker arm oil control solenoid 2P connector: disconnected  
Test circuit VT SOL, PG1  
Test point 1 Rocker arm oil control solenoid 2P connector No. 1 (rocker arm oil control solenoid  
side)  
Test point 2 Rocker arm oil control solenoid 2P connector No. 2 (rocker arm oil control solenoid  
side)  
Fig. 413: Measuring Resistance Between Rocker Arm Oil Control Solenoid 2P Connector No.  
1 And No. 2  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
Is there 14-30 ohms at room temperature?  
YES : Go to step 3.  
NO : REPLACE THE ROCKER ARM OIL CONTROL VALVE , then do the repair verification .  
3. Shorted wire check (VT SOL line):  
ο‚‘
ο‚‘
1. Jump the SCS line with the HDS.  
2. Disconnect the following connector.  
PCM connector B (49P)  
ο‚‘
3. Check for continuity between test points 1 and 2.  
Test condition IG LOCK (0)  
Rocker arm oil control solenoid 2P connector: disconnected  
PCM connector B (49P): disconnected  
Test circuit VT SOL  
Test point 1 PCM connector B (49P) No. 33 (GRN)  
Test point 2 Body ground  
Fig. 414: Checking Continuity Between PCM Connector B (49P) No. 33 (GRN) And Body  
Ground  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
Is there continuity?  
YES : Repair a short in the VT SOL wire between the rocker arm oil control solenoid and the PCM  
(B33), then do the repair verification .  
NO : The VT SOL wire is OK. Update the PCM See PCM UPDATE or PCM REMOVAL AND  
INSTALLATION if it does not have the latest software, or substitute a known-good PCM See PCM  
UPDATE or PCM REMOVAL AND INSTALLATION , then do the repair verification .  
REPAIR VERIFICATION  
ο‚‘
ο‚‘
ο‚‘
1. Reconnect all connectors.  
2. Turn the ignition switch to ON (II).  
3. Reset the PCM with the HDS See HOW TO TROUBLESHOOT THE FUEL AND EMISSIONS  
SYSTEMS or HOW TO TROUBLESHOOT THE A/T SYSTEM .  
ο‚‘
ο‚‘
ο‚‘
4. DO THE PCM IDLE LEARN PROCEDURE .  
5. Do the VTEC TEST in the INSPECTION MENU with the HDS.  
6. Check for Pending or Confirmed DTCs with the HDS.  
Confirmed  
DTC  
Pending  
DTC  
Freeze  
Frame  
DTC Description  
P2648 ROCKER ARM OIL CONTROL SOLENOID  
CIRCUIT LOW VOLTAGE  
Is DTC P2648 indicated?  
YES : Check for poor connections or loose terminals at the rocker arm oil pressure switch, the rocker arm oil  
control solenoid, and the PCM. If the PCM was updated, substitute a known-good PCM See PCM  
REMOVAL AND INSTALLATION or PCM UPDATE , then recheck. If the PCM was substituted, go to  
step 1.  
NO : Troubleshooting is complete. If the PCM was substituted, replace the original PCM See PCM UPDATE  
or PCM REMOVAL AND INSTALLATION . If any other Pending or Confirmed DTCs are indicated, go to  
the indicated DTC's troubleshooting.  
DTC P2649: ROCKER ARM OIL CONTROL SOLENOID CIRCUIT HIGH  
VOLTAGE  
Fig. 415: DTC Troubleshooting Flow Chart (P2649)  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
NOTE:  
Before you troubleshoot, record all freeze data and any on-board snapshot, and  
review the general troubleshooting information See HOW TO TROUBLESHOOT  
THE A/T SYSTEM or HOW TO TROUBLESHOOT THE FUEL AND EMISSIONS  
SYSTEMS .  
Confirmed  
DTC  
Pending  
DTC  
Freeze  
Frame  
DTC Description  
P2649 ROCKER ARM OIL CONTROL SOLENOID  
CIRCUIT HIGH VOLTAGE