Download
Table of Contents > DTC P065A: ACG No Charging Malfunction

Honda CR-V Programmed Fuel Injection (PGM-FI) system ➜ DTC P065A: ACG No Charging Malfunction

YES : Repair a short in the VCC wire between the PCM (A30, A35, B29) and each part that was  
disconnected in step 2, then do the repair verification .  
NO : Update the PCM See PCM REMOVAL AND INSTALLATION or PCM UPDATE if it does  
not have the latest software, or substitute a known-good PCM See PCM UPDATE or PCM  
REMOVAL AND INSTALLATION , then do the repair verification .  
REPAIR VERIFICATION  
ο‚‘
ο‚‘
ο‚‘
ο‚‘
1. Turn the ignition switch to LOCK (0).  
2. Reconnect all connectors.  
3. Turn the ignition switch to ON (II).  
4. Reset the PCM with the HDS See HOW TO TROUBLESHOOT THE A/T SYSTEM or HOW  
TO TROUBLESHOOT THE FUEL AND EMISSIONS SYSTEMS .  
ο‚‘
ο‚‘
5. DO THE PCM IDLE LEARN PROCEDURE .  
6. Check for Pending or Confirmed DTCs with the HDS.  
Confirmed  
DTC  
Pending  
DTC  
Freeze  
Frame  
DTC Description  
P0651 SENSOR REFERENCE VOLTAGE B  
MALFUNCTION  
Is DTC P0651 indicated?  
YES : Check for poor connections or loose terminals at the PCM and the following parts, then go to step 1.  




APP sensor  
A/C pressure sensor  
FTP sensor  
Input shaft (mainshaft) speed sensor  
NO : Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated  
DTC's troubleshooting.  
DTC P065A: ACG NO CHARGING MALFUNCTION  
Fig. 276: DTC Troubleshooting Flow Chart (P065A)  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
NOTE:  
Before you troubleshoot, record all freeze data and any on-board snapshot, and  
review the general troubleshooting information See HOW TO TROUBLESHOOT  
THE A/T SYSTEM or HOW TO TROUBLESHOOT THE FUEL AND EMISSIONS  
SYSTEMS .  
DTC Description  
Confirmed DTC Pending DTC Freeze Frame  
P065A ACG NO CHARGING MALFUNCTION  
1. DTC check:  
ο‚‘
1. Clear the DTC with the HDS See HOW TO TROUBLESHOOT THE A/T SYSTEM or  
HOW TO TROUBLESHOOT THE FUEL AND EMISSIONS SYSTEMS .  
ο‚‘
ο‚‘
2. Start the engine, and let it idle 1 minute.  
3. Check for Pending or Confirmed DTCs with the HDS.  
DTC Description  
Confirmed DTC Pending DTC Freeze Frame  
P0562 CHARGING SYSTEM LOW VOLTAGE  
Is DTC P0562 indicated?  
YES : DO THE DTC P0562 TROUBLESHOOTING.  
NO : Go to step 2.  
2. Problem verification:  
ο‚‘
1. Check for Pending or Confirmed DTCs with the HDS.  
DTC Description  
Confirmed DTC Pending DTC Freeze Frame  
P065A ACG NO CHARGING MALFUNCTION  
Is DTC P065A indicated?  
YES : Go to step 3.  
NO : Intermittent failure, the system is OK at this time. Check the alternator and the drive belt.  
3. Drive belt check:  
ο‚‘
1. INSPECT THE DRIVE BELT .  
Is the drive belt OK?  
YES : Repair or replace the alternator See ALTERNATOR OVERHAUL or ALTERNATOR  
REMOVAL AND INSTALLATION .  
NO : REPLACE THE DRIVE BELT .  
DTC P0685: PCM POWER CONTROL CIRCUIT/INTERNAL CIRCUIT  
MALFUNCTION  
Fig. 277: DTC Troubleshooting Flow Chart (P0685)  
Courtesy of AMERICAN HONDA MOTOR CO., INC.