Download
Table of Contents > 2. Symptom Tests > Volume Is Too High or Too Low When Driving at Freeway Speeds

Honda CR-V Audio System Troubleshooting & Testing ➜ Volume Is Too High or Too Low When Driving at Freeway Speeds

Fig. 262: Checking For Continuity Between Test Point Audio Unit Connector B (20P) No. 3  
(BLU) And Gauge Control Module 32P Connector No. 31 (BLU)  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
Is there continuity?  
YES : REPLACE THE AUDIO UNIT .  
NO : Repair an open in the wire(s) between the audio unit and the gauge control module.  
VOLUME IS TOO HIGH OR TOO LOW WHEN DRIVING AT FREEWAY SPEEDS  
Fig. 263: Audio System Symptom Troubleshooting Flowchart - Volume Is Too High Or Too Low When  
Driving At Freeway Speeds  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
NOTE:  


CHECK THE VEHICLE BATTERY CONDITION FIRST .  
If possible, have the customer demonstrate their concern and compare it  
against a known-good vehicle.  
1. Problem verification:  
ο‚‘
1. Test-drive the vehicle at freeway speeds and monitor the volume level.  
Is the volume level too high, or too low?  
YES : The failure is duplicated, go to step 2.  
NO : Intermittent failure, the system is OK at this time.  
2. Operation check:  
ο‚‘
1. Change the SVC mode setting in sound set-up to SVC MID.  
Is the volume level still too high, or too low?  
YES : REPLACE THE AUDIO-NAVIGATION UNIT .  
YES : REPLACE THE AUDIO UNIT .  
NO : Improper SVC setting for the customers sound taste.  
XM RADIO DISPLAY IS BLANK AND NO STATION INFORMATION IS DISPLAYED  
(NAVIGATION)  
Fig. 264: Audio System Symptom Troubleshooting Flowchart - XM Radio Display Is Blank And No  
Station Information Is Displayed  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
NOTE:  


CHECK THE VEHICLE BATTERY CONDITION FIRST .  
Check the connectors for poor connections or loose terminals.  
1. Determine possible failure area (related GA-NET circuit, others):  
ο‚‘
1. Turn the ignition switch to ON (II).  
ο‚‘
2. Turn on the audio system, and press the AUDIO button to check if the multi-information display  
changes to the audio information screen.  
Is the audio information displayed?