Download
Table of Contents > 2. Symptom Tests > Audio-Navigation Unit Does Not Exit Anti-Theft Mode

Honda CR-V Audio System Troubleshooting & Testing ➜ Audio-Navigation Unit Does Not Exit Anti-Theft Mode

Fig. 86: Checking For Continuity Between Test Point Audio-Navigation Unit Connector E  
(16P) No. 9 (BLU) And Gauge Control Module 32P Connector No. 31 (BLU)  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
Is there continuity?  
YES : REPLACE THE AUDIO-NAVIGATION UNIT .  
NO : Repair an open in the wire(s) between the audio-navigation unit and the gauge control module.  
AUDIO-NAVIGATION UNIT DOES NOT EXIT ANTI-THEFT MODE  
Fig. 87: Audio System Symptom Troubleshooting Flowchart - Audio-Navigation Unit Does Not Exit Anti-  
Theft Mode  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
NOTE:  


CHECK THE VEHICLE BATTERY CONDITION FIRST .  
Check for B-CAN and F-CAN DTCs and resolve them before  
troubleshooting.  

Check the connectors for poor connections or loose terminals.  
1. Problem verification:  
ο‚‘
1. Turn the ignition switch to ON (II).  
2. Press and hold the VOLUME/POWER knob more than 2 seconds to release the anti-theft mode.  
ο‚‘
Is the anti-theft mode released?  
YES : Intermittent failure, the system is OK at this time.  
NO : The failure is duplicated, go to step 2.  
2. Open wire check (B CAN-H line, B CAN-L line):  
ο‚‘
1. Turn the ignition switch to LOCK (0).  
2. Disconnect the following connectors.  
ο‚‘
Audio-navigation unit connector E (16P)  
Gauge control module 32P connector  
ο‚‘
3. Check for continuity between test points 1 and 2.  
Test condition IG LOCK (0)  
Audio-navigation unit connector E (16P): disconnected  
Gauge control module 32P connector: disconnected  
Test circuit B CAN-H  
Test point 1 Audio-navigation unit connector E (16P) No. 1 (PNK)  
Test point 2 Gauge control module 32P connector No. 30 (PNK)  
Test circuit B CAN-L  
Test point 1 Audio-navigation unit connector E (16P) No. 9 (BLU)  
Test point 2 Gauge control module 32P connector No. 31 (BLU)  
Fig. 88: Checking For Continuity Between Test Point Audio-Navigation Unit Connector E  
(16P) No. 9 (BLU) And Gauge Control Module 32P Connector No. 31 (BLU)  
Courtesy of AMERICAN HONDA MOTOR CO., INC.  
Is there continuity?  
YES : REPLACE THE AUDIO-NAVIGATION UNIT .  
NO : Repair an open in the wire(s) between the audio-navigation unit and the gauge control module.  
AUDIO-NAVIGATION UNIT POWER SWITCH WILL NOT TURN ON (NO AUDIO INFORMATION  
DISPLAY AND NO SOUND)