Download
Table of Contents > Maintenance > Checking and Maintaining Wiper Blades

2019 Honda CR-V Owner's Manual ➜ Checking and Maintaining Wiper Blades

Checking and Maintaining Wiper Blades  
Checking Wiper Blades  
1Changing the Front Wiper Blade Rubber  
If the wiper blade rubber has deteriorated, it will leave streaks and the hard surfaces  
of the blade may scratch the window glass.  
NOTICE  
Avoid dropping the wiper arm onto the windscreen,  
it may damage the wiper arm and/or the windscreen.  
Changing the Front Wiper Blade Rubber  
1. Turn the ignition switch to LOCK (0*1.  
2. While holding the wiper switch in the  
MIST position, turn the ignition switch to  
ON (w*1, then to LOCK (0*1.  
u Both wiper arms are set to the  
maintenance position as shown in the  
image.  
3. Lift both wiper arms.  
*1: Models with the keyless access system have an ENGINE START/STOP button instead of an  
ignition switch.  
702  
 
uuChecking and Maintaining Wiper BladesuChanging the Front Wiper Blade Rubber  
4. Press and hold the tab, then slide the  
holder off the wiper arm.  
Tab  
5. Pull the end of the wiper blade in the  
direction of the arrow in the image until it  
is out of the holder’s end cap.  
Blade  
End Cap At  
The Bottom  
6. Pull the wiper blade in the opposite  
direction to slide it out of the holder.  
Blade  
Holder  
Continued  
703  
uuChecking and Maintaining Wiper BladesuChanging the Front Wiper Blade Rubber  
7. Insert the flat side of the new wiper blade  
onto the bottom part of the holder. Insert  
Blade  
the blade all the way.  
8. Install the end of the wiper blade into the  
cap.  
9. Slide the holder onto the wiper arm until it  
locks.  
Holder  
10. Lower both wiper arms.  
11. Turn the ignition switch to ON (w*1 and  
hold the wiper switch in the MIST position  
until both wiper arms return to the  
standard position.  
Cap  
*1: Models with the keyless access system have an ENGINE START/STOP button instead of an  
ignition switch.  
704  
uuChecking and Maintaining Wiper BladesuChanging the Rear Wiper Blade Rubber  
Changing the Rear Wiper Blade Rubber  
1. Raise the wiper arm off.  
2. Pivot the bottom end of the wiper blade up  
until it comes off from the wiper arm.  
1Changing the Rear Wiper Blade Rubber  
Wiper Arm  
NOTICE  
Avoid dropping the wiper arm; it may damage the  
rear window.  
3. Slide the blade out of the wiper.  
Blade  
4. Remove the retainers from wiper blade and  
mount to a new rubber blade.  
Retainer  
Continued  
705  
 
uuChecking and Maintaining Wiper BladesuChanging the Rear Wiper Blade Rubber  
5. Slide the new wiper blade onto the holder.  
u Make sure it is engaged correctly, then  
Holder  
install the wiper blade assembly onto the  
wiper arm.  
706