HomeLink® Universal Transceiver*
1HomeLink® Universal Transceiver*
The HomeLink® Universal Transceiver can be programmed to operate up to three
remote controlled devices around your home, such as garage doors, lighting, or
home security systems.
HomeLink® is a registered trademark of Gentex
Corporation.
Before programming HomeLink to operate a garage
door opener, confirm that the opener has an external
entrapment protection system, such as an “electronic
eye,” or other safety and reverse stop features. If it
does not, HomeLink may not be able to operate it.
Important Safety Precautions
■
Refer to the safety information that came with your garage door opener to test that
the safety features are functioning properly. If you do not have the safety
information, contact the manufacturer.
Before programming HomeLink, make sure that people and objects are out of the
way of the garage or gate to prevent potential injury or damage.
When programming a garage door opener, park just outside the garage door’s
path.
Training HomeLink
If you have not trained any of the buttons in
Red Indicator
HomeLink before, you should erase any
previously learned codes. To do this:
• Press and hold the two outside buttons for
about 20 seconds, until the red indicator
blinks. Release the buttons, and proceed to
step 1.
• If you are training the second or third
button, go directly to step 1.
* Not available on all models
282
uuHomeLink® Universal Transceiver*uTraining HomeLink
1Training a Button
Training a Button
■
Retraining a Button
1. Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from the
If you want to retrain a programmed button for a
new device, you do not have to erase all button
memory. You can replace the existing memory code
using this procedure:
HomeLink button you want to program.
2.
Press and hold the desired HomeLink button and the button on
the remote transmitter. Does the HomeLink indicator (LED)
blink after 10 secs?
1.
Press and hold the desired HomeLink button
until the HomeLink indicator begins to blink.
NO
NO
YES
Standard transmitter
Indicator remains on
for about 25 secs.
Rolling code transmitter
Indicator blinks rapidly for
2 secs, then remains on for
about 23 secs.
a.
Press and hold the remote and the HomeLink
button at the same time. Then, while
continuing to hold the HomeLink button,
press and release the button on the remote
every 2 secs.
3.
Press and hold the
programmed HomeLink
button for about a sec.
Does the device (garage
door opener) work?
YES
2.
Continue to hold the HomeLink button and
follow steps 1 - 3 under “Training a Button.”
Does the LED blink within 20 secs?
YES
NO
Erasing Codes
To erase all the codes, press and hold the two outside
buttons until the HomeLink indicator begins to blink
(about 10 to 20 secs). You should erase all codes
before selling the vehicle.
4.
Press and hold the HomeLink button again.
Training
Complete
HomeLink indicator blinks for 2 secs,
HomeLink LED
is on.
then remains on.
If you have any problems, see the device’s
HomeLink at 1-800-355-3515.
a.
b.
The remote has a rolling code. Press the
“learn” button on the remote-controlled
device (e.g. garage door opener).
5.
Press and hold the HomeLink
button again.
The remote-controlled device
should operate.
Within 30 secs, press and hold the
programmed HomeLink button for 2 secs.
Training Complete
283
2024 Honda CR-V Owner's Manual
2023 Honda CR-V Owner's Manual
2021 Honda CR-V Owner's Manual
2018 Honda CR-V Owner's Manual
2015 Honda CR-V Owner's Manual
