uuOperating the Switches Around the Steering WheeluWipers and Washers
Wipers and Washers
1Wipers and Washers
Windshield Wiper/Washer
β
NOTICE
The windshield wipers and washers can be
used when the power mode is in ON.
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.
β MIST
NOTICE
The wipers run at high speed until you release
the lever.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
Pull to
use
washer.
β Wiper switch (OFF, INT, LO, HI)
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes.
Move the lever up or down to change the
wiper settings.
Intermittent Time
Adjustment Ring*
β Adjusting wiper operation*
Turn the adjustment ring to adjust the wiper
operation.
Models with intermittent time adjustment ring
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operationβs
shortest delay setting ( ) and the LO setting become
the same.
MIST
OFF
Lower speed, fewer sweeps
INT
LO: Low speed wipe
HI: High speed wipe
Higher speed, more sweeps
NOTICE
In cold weather, the blades may freeze to the
windshield.
Operating the wipers in this condition may damage
the wipers. Use the defogger or heated windshield*
to warm the windshield, then turn the wipers on.
β Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windshield,
then stop.
If the wipers stop operating due to an obstacle such
as the buildup of snow, park the vehicle in a safe
place.
Rotate the wiper switch to OFF, and set the power
mode to ACCESSORY or VEHICLE OFF, then remove
the obstacle.
* Not available on all models
Continued
187
uuOperating the Switches Around the Steering WheeluWipers and Washers
Rear Wiper/Washer
β
The rear wiper and washer can be used when
the power mode is in ON.
β Wiper switch (OFF, INT, ON)
Change the wiper switch setting according to
the amount of rain.
β Washer (
)
Sprays on the rear window while you rotate
the switch to this position.
Hold it to activate the rear wiper and to spray
the washer. Once released, the washer spray
will stop and the rear wiper will return to its
selected switch setting after a few sweeps.
INT: Intermittent
ON: Continuous wipe
OFF
Washer
β Operating in reverse
When you shift the transmission to (R with the windshield wipers activated, the rear
wiper operates automatically as follows even if its switch is off.
Front Wiper Position
Rear Wiper Operation
INT (Intermittent)
Intermittent
LO (Low speed wipe)
HI (High speed wipe)
Continuous
188
2024 Honda CR-V Owner's Manual
2023 Honda CR-V Owner's Manual
2021 Honda CR-V Owner's Manual
2018 Honda CR-V Owner's Manual
2015 Honda CR-V Owner's Manual
