Download
Table of Contents > Controls > Operating the Switches Around the Steering Wheel > Wipers and Washers

2023 Honda CR-V Owner's Manual ➜ Wipers and Washers

uuOperating the Switches Around the Steering WheeluWipers and Washers  
Wipers and Washers  
Windshield Wiper/Washer  
■
NOTICE  
The windshield wipers and washers can be  
used when the power mode is in ON.  
■ MIST  
Do not use the wipers when the windshield is dry.  
The windshield will get scratched, or the rubber  
blades will get damaged.  
The wipers run at high speed until you release  
the lever.  
■ Wiper switch (OFF, INT*1, AUTO*2, LO,  
HI)  
NOTICE  
Pull to  
use  
washer.  
In cold weather, the blades may freeze to the  
windshield.  
Operating the wipers in this condition may damage  
the wipers. Use the defogger or heated windshield*  
to warm the windshield, then turn the wipers on.  
Move the lever up or down to change the  
wiper settings.  
■ Adjusting wiper operation*  
Turn the adjustment ring to adjust the wiper  
operation.  
Intermittent Time  
Adjustment Ring*  
NOTICE  
Turn the washers off if no washer fluid comes out.  
The pump may get damaged.  
MIST  
Lower speed, fewer sweeps  
OFF  
INT*1/AUTO*2  
LO: Low speed wipe  
HI: High speed wipe  
Models with intermittent time adjustment ring  
If the vehicle speeds up while the wipers are  
operating intermittently, the length of the wipe  
interval shortens.  
Higher speed, more sweeps  
When the vehicle speeds up, the wiper operation’s  
shortest delay setting ( ) and the LO setting become  
the same.  
■ Washer  
Sprays while you pull the lever toward you.  
When you release the lever for more than one  
second, the spray stops, the wipers sweep two  
or three more times to clear the windshield,  
then stop.  
If the wipers stop operating due to an obstacle such  
as the buildup of snow, park the vehicle in a safe  
place. Rotate the wiper switch to OFF, and set the  
power mode to ACCESSORY or VEHICLE OFF, then  
remove the obstacle.  
*1: Models with manual intermittent operation  
*2: Models with automatic intermittent operation  
* Not available on all models  
196  
 
uuOperating the Switches Around the Steering WheeluWipers and Washers  
1Wipers and Washers  
Automatic Intermittent Wipers*  
■
The wiper motor may stop motor operation  
temporarily to prevent an overload. Wiper operation  
will return to normal within a few minutes.  
When you push the lever down to AUTO, the  
windshield wipers sweep once, and go into  
the automatic mode.  
The wipers operate intermittently, at low  
speed, or at high speed and stop in  
accordance with the amount of rainfall the  
rainfall sensor detects.  
The rainfall sensor is in the location shown below.  
Rainfall Sensor  
Adjustment Ring  
■ AUTO sensitivity adjustment  
When the wiper function is set to AUTO, you  
can adjust the sensitivity of the rainfall sensor  
(using the adjustment ring) so that wipers will  
operate in accordance with your preference.  
Sensor sensitivity  
NOTICE  
AUTO should always be turned OFF before the  
following situations in order to prevent severe  
damage to the wiper system:  
• Cleaning the windshield  
Low sensitivity  
• Driving through a car wash  
• No rain present  
High sensitivity  
* Not available on all models  
Continued  
197  
 
uuOperating the Switches Around the Steering WheeluWipers and Washers  
Rear Wiper/Washer  
■
The rear wiper and washer can be used when  
the power mode is in ON.  
■ Wiper switch (OFF, INT, ON)  
Change the wiper switch setting according to  
the amount of rain.  
*
■ Washer (  
,
)
Sprays on the rear window and rearview camera*  
while you rotate the switch to this position.  
Hold it to activate the rear wiper and to spray  
the washer. Once released, the washer spray  
will stop and the rear wiper will return to its  
selected switch setting after a few sweeps.  
INT: Intermittent  
ON: Continuous wipe  
OFF  
Washer  
■ Operating in reverse  
When you put the transmission into (R with the windshield wipers activated, the  
rear wiper operates automatically as follows even if its switch is off.  
Front Wiper Position  
Rear Wiper Operation  
INT*1 (Intermittent)  
Intermittent  
AUTO*2 (Intermittent)  
LO (Low speed wipe)  
HI (High speed wipe)  
Continuous  
*1: Models with manual intermittent operation  
*2: Models with automatic intermittent operation  
* Not available on all models  
198