Fig. 2: Identifying Front Individual Map Light, Ceiling Light And Related Components
Courtesy of AMERICAN HONDA MOTOR CO., INC.
ALTERNATOR
SYMPTOM TROUBLESHOOTING
REMOVAL, INSTALLATION, AND
TEST
AMBIENT LIGHT
MEASUREMENT PARASITIC DRAW
SYMPTOM TROUBLESHOOTING
TEST
BATTERY
BATTERY SENSOR
REMOVAL AND INSTALLATION
REMOVAL, INSTALLATION, AND
TEST
CARGO AREA LIGHT
REMOVAL, INSTALLATION, AND
TEST
CEILING LIGHT
FRONT INDIVIDUAL MAP LIGHT
MICU (Built into the under-dash fuse/relay box)
REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
TEST
TAILGATE LATCH SWITCH (Built into the tailgate
latch)
VANITY MIRROR LIGHT
TEST
BATTERY REMOVAL AND INSTALLATION
REMOVAL
1. Battery Terminal - Disconnection
1. Make sure the ignition switch is in LOCK (0).
2. Disconnect and isolate the negative cable (A) from the battery.
NOTE:
Always disconnect the negative side first.
3. Disconnect the positive cable (B) from the battery.
Fig. 3: Identifying Battery Negative And Positive Cable
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Battery
1. Remove the battery setting plate (A) and the battery (B).
Fig. 4: Identifying Battery And Setting Plate
Courtesy of AMERICAN HONDA MOTOR CO., INC.
INSTALLATION
1. Battery
1. Install the battery (A) and the battery setting plate (B).
NOTE:
Do not deform the battery setting plate by over-tightening the nuts.
Fig. 5: Identifying Battery And Setting Plate
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Battery Terminal - Reconnection
NOTE: If the battery performance is abnormal, test the battery.
1. Clean the battery terminals.
2. Connect the positive cable (A) to the battery.
NOTE:
Always connect the positive side first.
3. Connect the negative cable (B) to the battery.
4. Apply multipurpose grease to the terminals to prevent corrosion.
Fig. 6: Connecting Battery Terminals With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
BATTERY SENSOR REMOVAL AND INSTALLATION
REMOVAL
1. Battery Sensor
1. Make sure the ignition switch is in LOCK (0).
2. Disconnect the connector from the battery sensor (A).
3. Remove the battery sensor from the battery.
4. Remove the cover (B).
5. Remove the negative terminal (C).
NOTE:
Do not hold the battery sensor connector (D), for protecting from
damage when removing the negative terminal.
2024 Honda CR-V Owner's Manual
2023 Honda CR-V Owner's Manual
2021 Honda CR-V Owner's Manual
2018 Honda CR-V Owner's Manual
2015 Honda CR-V Owner's Manual
